Hi,
I have a Work in Progress port of micropython for Rasberry Pi AROS and supports
the hardware peripherals as GPIO, UART, I2C, SPI, PWM.
Link :
https://github.co...icropython
Micropython is very close to the full Python 3 language, but with
some smaller differences :
https://docs.micr...index.html
This was tested on a Pi400 and GPIO + UART is confirmed to work.
When the peripherals are working a huge amount of device drivers
already available for micropython should then work out of the box.
If you have any device with the standard ports, there is a good chance
to find a ready drive on the internet.
Documentation for using the peripherals are found in the official
micropython site :
https://docs.micr...chine.html
Open issues:
- Open with icon not handled. Probably can be copied from lua port.
- Currently the input echo each line to the output (raw input fix with termios or maybe Dos?)
- Ctrl+C signal is not implemented. To exit : "import sys; sys.exit(0)"
- Raw 1MHz clock access used. ("timer.device" with UNIT_MICROHZ only seem to give 100Hz frequency)
1MHz clock needed for onewire bit banging and other accurate timing purposes.
- Enable/Disable used for critical timing sections. Not sure this is the right solution.
- GPIO interrupts seems to be available, but not implemented. Useful for buttons, encoders etc.
- Direct use of peripherals probably should be use the AROS api where available.
- Threading not enabled.
- Soft timer device is missing. Can probably be copied from the SDL3 port with separate running thread.
- Networking not enabled (socket module needed)
I was hoping someone with more in-depth knowledge of AROS could take a look at
this port and give some advice how to sanitize and improve the code for general
consumption.
Note : Connecting anything to the unprotected pins of your Rasberry Pi device could potential
destroy it.